The WMH-1 series wood drying oven can dry wood of various tree species, specifications, and purposes. It has the advantages of energy saving, safety, reliability, short drying cycle, good drying quality, and low drying cost. It is widely used in large, medium, and small wood processing enterprises, especially for manufacturers engaged in wood product export business. When the wood drying equipment is operating normally, the fuel is fully burned in the combustion chamber, generating heat energy, which is fully absorbed by the drying medium in the heat energy drying system, producing a temperature of about 170 degrees Celsius. Under the action of the circulating fan, the high-temperature airflow passes through the control system and conveying system, and the high-temperature hot air is transported to the drying chamber for drying treatment of the wood. At the same time, the steam generation device on the equipment can generate a large amount of atmospheric steam. According to the requirements of the drying process, the steam can be timely sent into the drying chamber to spray steam and adjust the humidity of the wood. The humidity control system is an independent steam system and is equipped with safety devices. Saturated wet steam can quickly make the surface humidity and internal humidity of wood consistent, thereby achieving the goal of drying both the interior and exterior of wood simultaneously. For solid and heavy hard and thick wood, intermittent heating drying technology can be used to solve the defects such as internal cracking, end cracking, and deformation that occur during the drying process, greatly improving the yield of wood products. The wood drying equipment is equipped with a heat recovery system, which fully utilizes the drying medium and minimizes the heat loss caused by the emission of hot and humid air. The recycling and utilization of heat energy significantly reduces drying costs and shortens drying cycles. When the moisture content of wood drops below 15%, after 6-8 hours of high-temperature dry steaming, all parasitic insects and their eggs inside the wood can be eliminated, solving the adverse effects caused by insects and improving the economic efficiency of the enterprise. The inlet and return air ducts of the equipment are equipped with adjustable valves, which can adjust the inlet and swirling air volume at any time according to the drying process requirements of the wood. There is also an adjustable compensation at the inlet of the fan, which can be used to adjust the air pressure and volume in the drying room. A steam spray regulating valve is installed on the main body of the equipment to adjust the steam spray amount according to the different needs of wood drying. There is also a combustion assisting device at the lower part of the equipment body. When the fuel is not easy to burn due to various reasons, the combustion assisting valve can be opened to increase the combustion force and reach the temperature required for each drying stage. Users can flexibly design the size of the drying room according to their own drying quantity requirements, ranging from 10 cubic meters to 150 cubic meters. (If the drying quantity exceeds 150 cubic meters at once, we recommend using a steam drying kiln. Our factory's kilns with a capacity of over 150 cubic meters are fully automatic controlled, see separate introduction, price guarantee). This equipment has a small initial investment and is relatively easy to operate. It can be designed as a semi-automatic operation (automatic dehumidification, automatic humidification) according to your company's requirements, which is a choice for small and medium-sized enterprises The system includes an intake duct, a return duct, a main fan, a moisture removal system, a hot air stove, and control instruments (including wet and dry bulb instruments).

Main technical parameters: